MAX Falcon-8

Liens

• maxkeyboard
• massdrop

Modes de rétroéclairage

Utiliser le bouton en haut à droite pour passer d'un mode à l'autre.

• 0) Off
• 1) Level 1 low
• 2) Level 2 medium
• 3) Level 3 high
• 4) Level 4 pulse
• 5) Level 5 Fade in mode
• 6) Level 6 Fade out mode
• 7) Level 7 Random mode
• 8) Level 8 Cycle mode

Modifier la configuration des touches

1. Connect micro USB cable to your Falcon-8 and then plug in the USB cable to your computer.
2. Flip the device over and simply remove jumper from "Jumper 0" (en haut à gauche) and then place onto "jumper 1" (en haut à droite).
3. Slowly press the "Reset" button (en haut à gauche) twice.
4. A temporary "CRP DISABLD" drive will display in "My Computer / This PC"
5. Open "MAX Falcon-8 V2.1 Programmer.exe" and load the "Firmware.bin" from "CRP DISABLD" drive.
6. Simply assign the function of each key from the drop down list or set your own macro or key combinations.
7. When satisfied with your settings, click "SAVE"
8. Flip the device over and remove jumper from "Jumper 1" (en haut à droite) and place it back to "Jumper 0" (en haut à gauche)
9. Lastly, Press the "Reset" button once.

Erreur « Component comdlg32.ocx or one of its dependecies not correct registered »

WINDOWS WITH 64-bit OPERATING SYSTEM TYPE

1. place comdlg32.ocx to Windows\SysWOW64 folder
2. Run command prompt with administrator privilege.
3. type the following command and then hit enter key

regsvr32 %Systemroot%\SysWOW64\comdlg32.ocx